Purposes: 
 Heated water bath for distillation, drying, concentration and dipping chemicals. 
 Forms: divided into single row and double-column type 
 【Single row] 
 Model: HH.1 hole: a hole diameter: 125mm Depth: 95mm Power: 300W 
 Model: HH.2 number of holes: 2 hole diameter: 125mm Depth: 95mm Power: 600W 
 Model: HH.4 number of holes: 4 hole diameter: 125mm Depth: 95mm Power: 1000W 
 Model: HH.6 number of holes: 6 hole diameter: 125mm Depth: 95mm Power: 1500W 
 [Dual-column] 
 Model: HH.4 number of holes: 4 hole diameter: 125mm Depth: 95mm Power: 800W 
 Model: HH.6 number of holes: 6 hole diameter: 125mm Depth: 95mm Power: 1500W 
 Model: HH.8 Kong: 8 hole diameter: 125mm Depth: 95mm Power: 2000W 

 Note: (1) pattern in the effective size of d is the hole cover fully open. 
 ⑵ h is the effective size of the shelf to a water bath plane. 

 Structure: 
 This product is the sink type, the largest diameter of the aperture 12 cm, each hole pot with the four ring and a cover stamping made of single piece of stainless steel (or stainless steel plate is welded), shell selection of high quality steel sheet and spray. Heating tube in the middle of the water, heating, low power consumption. And equipped with a digital display temperature device (smart temperature), according to the instructions in the use of the temperature controller: adjust the range of 0-100 ° C ± 1.5 ° C, depending on the user can adjust the water temperature. 
 Usage: 
 Must first add water when used in the pan (also according to the needed temperature by adding hot water to shorten the heating time), power, turn the power switch, according to the instructions in the smart temperature controller (KW-1000DC) to select the The required temperature can be temperature controller automatic thermostat. The work is completed, cut off the power. 
 Note: 
 A. This product uses 220V AC mains power line with three-wire safety plugs and sockets. Be sure to use the safety ground to prevent leakage. 
 Two. Temperature sensor in the interior of the pot and a metal tube for the transmission temperature signal, not to collisions and the severe vibration, to prevent temperature control failure. 
 3. The pot is strictly prohibited anhydrous heating, water should be higher than the heating pipe, otherwise it will burn out the heating pipe.